Ok this is the case i have a new server. running ensim pro i setup a dns from the ensim control panel and then after had to bind the ips to a eth0 via ssh. I have completed those step and everything also change the ip from the domain registrar as well and all that also ran a dig command and it shows up the new ip on ns1 and ns2 however i am still not quite sure if everything is setup ok because for one when visit a site its still going ot the old server when i do a dns report or any such of dns trace it shows up the new ip



Is there a way to check and make sure my dns is ok bind properly and running ok no conflick issue etc.